In this article:
Note that there are two methods of managing drying equipment in Encircle. What you see when you go to place equipment on the job will be determined by the settings your org admin has enabled for your company.
If you are prompted to choose from an inventory list with models and asset ID's when you try to place equipment, that means your org has Inventory equipment turned on, and you should go here for instructions on that.
In this article, you'll learn how to place equipment using our Quick Add method. Watch the following video or refer to the instructions below.
Placing Equipment on the Job
- Open the Equipment Placement task.
- Tap the red + button.
- Choose a room to start with.
- Tap the + button next to the type of equipment you wish to add. Continue until you've met or exceeded the recommendations for the room.
Make sure to repeat these steps for each room in the chamber:
- Tap the room selector at the top left.
- Select the next room.
- Add your equipment using the + button.
When you've met the recommendations for each room in the chamber, tap Place.
Placing Equipment on the Moisture Map
You may want to place your equipment on your moisture map. For this:
- Open the Room Moisture Map task.
- Select a moisture map.
- Tap Place.
- Select Place Existing.
- Under the Equipment tab, select Place All.
- Drag the icons to their respective positions on the map.
*Check out our EncircleU course "Hydro for Technicians" for a more in-depth and interactive learning experience on the Hydro tool.
Updated